+- ispCP - Board - Support (http://www.isp-control.net/forum)
+-- Forum: ispCP Omega Development Area (/forum-1.html)
+--- Forum: General discussion (/forum-11.html)
+--- Thread: Spam Filtering (/thread-281.html)
RE: Spam Filtering - ephigenie - 04-11-2007 06:00 PM
yes - everything is prepared to integrate the maia (ok not the automatic setup atm)
but i still got no answer.
I'll write him again.
RE: Spam Filtering - xyladecor - 04-11-2007 06:19 PM
ephigenie Wrote:yes - everything is prepared to integrate the maia (ok not the automatic setup atm)
but i still got no answer.
I'll write him again.
GREAT! I've wrote André Pohl five minutes ago...
i think it's the best way to install it in the tools directory under vu2000? correct me if i'm wrong...
RE: Spam Filtering - BeNe - 04-11-2007 09:19 PM
Looks OK for me in the tools directory. But the question with vu2000 ? I´m not sure.
Can other then also Access Maia?
RE: Spam Filtering - ephigenie - 04-11-2007 09:23 PM
Yeah - we thought to integrate it beneath the pma & webmail so we got it under /tools/antispam/
There would it be accessible from everyone who's access to the panel-vhost
RE: Spam Filtering - xyladecor - 04-11-2007 10:04 PM
ephigenie Wrote:Yeah - we thought to integrate it beneath the pma & webmail so we got it under /tools/antispam/
There would it be accessible from everyone who's access to the panel-vhost
okay,
i'll start today with a fresh installation of sarge and beginn with the basic howto. i hope i'll get the okay from andré, then i'll post the file here, because most of the steps are the same.
RE: Spam Filtering - BeNe - 04-11-2007 10:10 PM
Why dont you use Etch ? Etch is stable now and every new system will now run under Etch!
RE: Spam Filtering - xyladecor - 04-11-2007 10:33 PM
okay on etch
RE: Spam Filtering - Some_Bored_Dude - 04-12-2007 01:01 AM
I would be interested in testing this how-to when you need a draft. I've just purchased a new system dedicated for spam filtering, but to have something built into omega will reduce the amount of panels to open access for clients.
RE: Spam Filtering - xyladecor - 04-12-2007 02:27 AM
i got an okay from andré. almost 50%-60% of the german howto is ready! my etch installation is running. will be ready before WM 2010
RE: Spam Filtering - BeNe - 04-12-2007 02:30 AM
xyladecor Wrote:i got an okay from andré. almost 50%-60% of the german howto is ready! my etch installation is running. will be ready before WM 2010
hehe - we will see
Thanks André for the OK!