+- ispCP - Board - Support (http://www.isp-control.net/forum)
+-- Forum: ispCP Omega Support Area (/forum-30.html)
+--- Forum: Usage (/forum-34.html)
+--- Thread: Login issue (/thread-10990.html)
Login issue - Cdmar - 06-17-2010 07:51 PM
Hello,
I have ispCp 1.0.5 installed and running on a Debian 5 system.
I noticed that there is a problem with logging-in.
If I enter everything correctly (login & password) right at the first time, it goes through just fine. However, if I will provide a wrong password at first login attempt, it will not allow me to log-in anymore after the first attempt, even entering correct password many times afterwards. It just reloads the page and returns me back to log-in. So to tell it in brief, I have to enter
correct data right from the start to log-in, if I will somehow provide it wrong, it will not allow me to log-in anymore after the first login attempt. I already tried disabling brute-force detection or block-time between logins, it didn't help. I don't know what is the issue.
I would be glad if someone would take time to help me looking into and solving this technical problem.
Thanks in advance.
RE: Login issue - Nuxwin - 06-17-2010 07:53 PM
Hello ;
I know this problem. Go into the ispCP database (via pma) and remove the related line into the login table. Normally, that should solve your problem.
Best Regards ;
RE: Login issue - Cdmar - 06-17-2010 07:56 PM
Thank you for your fast reply.
Which line should that be?
RE: Login issue - BeNe - 06-17-2010 07:57 PM
The Line with your IP-Adresse.
Greez BeNe
RE: Login issue - Cdmar - 06-17-2010 08:02 PM
Thanks, I guess this makes it work. However, is there no way to prevent this login-bug from occuring in the future? Will I always have to manually delete entries? It sometimes logs my users in as "Unknown", at least that's what I can see in the active users tab of ispcp. I have to kill the "Unknown" user session before the person can succesfuly login again.
RE: Login issue - Nuxwin - 06-17-2010 08:17 PM
(06-17-2010 08:02 PM)Cdmar Wrote: Thanks, I guess this makes it work. However, is there no way to prevent this login-bug from occuring in the future? Will I always have to manually delete entries? It sometimes logs my users in as "Unknown", at least that's what I can see in the active users tab of ispcp. I have to kill the "Unknown" user session before the person can succesfuly login again.
I'll open a new ticket for this issue. Will be fixed ASAP and then, solution will be reported here.
Ok, I've doing some test with the latest trunk state. I can't reproduce the behavior.
EDIT:
1. I've strong password several time
Result:
Blocked for....
3. I waited until the end of blocker time
4. Login with correct authentication information
Result: Works fine.
Only one issue still exists: the login_counter field in the login table is set to 2 on the first login.
RE: Login issue - fastgraph - 06-18-2010 04:57 PM
I had the same problem and it didn't let me login for an hour... You can bypass it by disabling the "Block time between logins" option in the settings...