ispCP - Board - Support
I delete files by mistake, because i am a looser! - Printable Version

+- ispCP - Board - Support (http://www.isp-control.net/forum)
+-- Forum: ispCP Omega Support Area (/forum-30.html)
+--- Forum: System Setup & Installation (/forum-32.html)
+--- Thread: I delete files by mistake, because i am a looser! (/thread-1412.html)



I delete files by mistake, because i am a looser! - robmorin - 09-28-2007 02:06 AM

Hello all... i seemed to have deleted some files in /var/www

i managed to restore some of them, but i am not sure what i am missing, as now i only get the nice
"Cannot open the ispcp.conf config file " when i go to iscpcp via my browser...

I delete the fcgi dir and everything below it, i put back what i had on backup which was not much, just the php4 & php5 dirs and the master dir all were empty i through in a php-start file i found in /etc/ispcp/fcgi into /var/www/fcgi/master... but no go any suggestions

Thanks to all..

Rob the IDIOT!


RE: I delete files by mistake, because i am a looser! - BeNe - 09-28-2007 04:30 AM

Ok - looks like there is no more that can be used Rolleyes
Try to uninstall ispCP - and reinstall it. Then copy a Backup (if there is one of your Pages). You find the uninstall in the engine folder.

Greez BeNe


RE: I delete files by mistake, because i am a looser! - robmorin - 09-28-2007 06:06 AM

BeNe Wrote:Ok - looks like there is no more that can be used Rolleyes
Try to uninstall ispCP - and reinstall it. Then copy a Backup (if there is one of your Pages). You find the uninstall in the engine folder.

Greez BeNe

Well i fixed by editing this line in /var/www/fcgi/master/php4/php.ini which i put back a virgin file..

open_basedir = "/var/www/ispcp/:/etc/ispcp/:{MR_LOCK_FILE}:/proc/:/bin/df:/bin/mount:{RKHUNTER_LOG}:{CHKROOTKIT_LOG}:/usr/share/pear/{OTHER_ROOTKIT_LOG}"

once i put that file back with proper perms it worked ok...

one i told it where the conf file was all worked fine
Smile

Rob..


RE: I delete files by mistake, because i am a looser! - RatS - 09-28-2007 06:43 AM

other solution: set all domains to "toadd" and let rqst-mngr start: should work, too.