+- ispCP - Board - Support (http://www.isp-control.net/forum)
+-- Forum: ispCP Omega Support Area (/forum-30.html)
+--- Forum: Update/Upgrade (/forum-44.html)
+--- Thread: Ugrade RC7 to 1.0 on a load balance system. (/thread-5974.html)
Ugrade RC7 to 1.0 on a load balance system. - timaaarrreee - 03-08-2009 06:37 PM
Hi everyone,
Today I setup some servers running the latest software (ispCP 1.0, debian lenny)
But i am still running my old server in production.
My old server has ispCP 1RC7 running on etch and i want to migrate it to my new servers (panel.khost.co.nz, sql.khost.co.nz, files.khost.co.nz)
Which are running lenny and panel.khost.co.nz ispCP 1.0
I am unsure on how migrate everthing over. and the howto was made for ispCP RC2 http://www.isp-control.net/documentation/howto/miscellaneous/migrate_from_one_to_another_ispcp_server
Should i try this?
RE: Ugrade RC7 to 1.0 on a load balance system. - timaaarrreee - 03-15-2009 11:24 AM
no posts?
RE: Ugrade RC7 to 1.0 on a load balance system. - rbtux - 03-15-2009 11:42 AM
I think you might have to figure that out by your self.
Setup a lab environment for that purpose. When you have specific questions I'm sure there are some guys around which can help you sort the problems out...
But a generic howto from a non standard setup to another non standard setup is a bit much to expect from a volunteer support forum
Sorry for not beeing more helpful
RE: Ugrade RC7 to 1.0 on a load balance system. - timaaarrreee - 04-01-2009 04:11 PM
(03-15-2009 11:42 AM)rbtux Wrote: I think you might have to figure that out by your self.
Setup a lab environment for that purpose. When you have specific questions I'm sure there are some guys around which can help you sort the problems out...
But a generic howto from a non standard setup to another non standard setup is a bit much to expect from a volunteer support forum
Sorry for not beeing more helpful
Ok, I see its a bit much to ask... Its more the fact from moving from one phisical server to another one. I would like to know if its possible. With that Howto that is already there.