+- ispCP - Board - Support (http://www.isp-control.net/forum)
+-- Forum: ispCP Omega Support Area (/forum-30.html)
+--- Forum: System Setup & Installation (/forum-32.html)
+--- Thread: fcgid or fastcgi? (perl ./ispcp-setup) (/thread-6344.html)
fcgid or fastcgi? (perl ./ispcp-setup) - kwutzke - 04-09-2009 02:36 AM
Everything seems to have gone right installing ispCP on a relatively low resource level vserver.
I just can't see, even after googling, what to choose between
FastCGI Version: [f]cgid or fast[c]gi. [fcgid]:
...
Taking under consideration
http://www.isp-control.net/documentation/howto/miscellaneous/run_ispcp_on_a_low_resources_system
my emotional choice would be to go for FastCGI, but fcgid is the default.
What do I choose for a low resources system? 250 MB RAM guaranteed, 512 MB max., 20 GB HD...
Karsten
RE: fcgid or fastcgi? (perl ./ispcp-setup) - Lucan - 04-09-2009 04:55 AM
it doesn't realy matter, just take one.
You can easily change it after the installation again.
So just figure out what's working best for you.