ispCP - Board - Support
perl ./ispcp-setup - Printable Version

+- ispCP - Board - Support (http://www.isp-control.net/forum)
+-- Forum: ispCP Omega Support Area (/forum-30.html)
+--- Forum: System Setup & Installation (/forum-32.html)
+--- Thread: perl ./ispcp-setup (/thread-6442.html)



perl ./ispcp-setup - Gymnogyp - 04-17-2009 04:32 PM

Ok, I finally installed ISPCP. One question tho....

At first I ran the ./ispcp-setup script and decided to use FastCGI... after the setup finished, I changed my mind so...

I ran the ./ispcp-setup a second time and chose fcgid.

My question is, will running the install script a second (or third, or fourth) time mess anything up? Or, does it just update all the existing install and config?

Thanks a lot, I'm a complete n00b learning the ropes! Wink


RE: perl ./ispcp-setup - BeNe - 04-17-2009 04:52 PM

The best way is to change disable the mod_fastcgi and enable mod_fcgid manually. So no new setup is need.

Greez BeNe


RE: perl ./ispcp-setup - Gymnogyp - 04-18-2009 01:09 AM

thank yu for your answer. that wasn't really my question tho. i already ran the setup script a second time. my question is... would running that script again mess anything up?

not just for fcgid... but for all settings.

thanks Wink


RE: perl ./ispcp-setup - BeNe - 04-18-2009 07:39 PM

I´m sure that the script mess anything up not only fcgid.

Greez BeNe