+- ispCP - Board - Support (http://www.isp-control.net/forum)
+-- Forum: ispCP Omega Support Area (/forum-30.html)
+--- Forum: System Setup & Installation (/forum-32.html)
+--- Thread: Fresh Install (/thread-7044.html)
Fresh Install - Sovaka - 06-24-2009 11:02 PM
Hey
I have just recently ventured to Linux as I wish to setup a server.
Having found ispCP with Webmin, I think it is a winning combination.
However, failing an install just previously and had to reinstall Ubuntu, I think I need a little help.
I have followed the main docs install instructions to the letter, but I had previously installed Webmin first, and messed with some configs.
Now that I have a clean OS install, I was wondering if someone can tell me the best path to follow to allow a trouble free install.
I read both on the forums and main docs, certain guides, but they conflict
At the moment, all I have done is downloaded system updates.
From here, what do I need to do to ensure a good install?
This is what I believe the install order to be;
#1 - LAMP
#2 - ispCP
#3 - Webmin
If this isn't the case, please let me know
Thanks.
~Sovaka
RE: Fresh Install - MasterTH - 06-24-2009 11:42 PM
why do u want to install lamp?
I would'nt do that. When u follow the installation steps u will install all needed applikations for webserving, mailing usw...
i'm not sure if the combination between lamp and ispcp is working
RE: Fresh Install - Sovaka - 06-25-2009 09:10 AM
(06-24-2009 11:42 PM)MasterTH Wrote: why do u want to install lamp?
I would'nt do that. When u follow the installation steps u will install all needed applikations for webserving, mailing usw...
i'm not sure if the combination between lamp and ispcp is working
So install ispCP first then webmin and I should have all that I need?
I'll give it a go.
RE: Fresh Install - Sovaka - 06-25-2009 11:22 AM
(06-25-2009 09:10 AM)Sovaka Wrote:(06-24-2009 11:42 PM)MasterTH Wrote: why do u want to install lamp?
I would'nt do that. When u follow the installation steps u will install all needed applikations for webserving, mailing usw...
i'm not sure if the combination between lamp and ispcp is working
So install ispCP first then webmin and I should have all that I need?
I'll give it a go.
It worked for the most part... Had to do some modifying, but the admin.domain.com wasn't working
Tried to find the error and all I could find was that I used case in my domain, which I take it is a bad thing. So I assume that is why it doesn't work.
So time for another reinstall :\
RE: Fresh Install - BeNe - 06-25-2009 04:04 PM
Is there a correct DNS entry for "admin.domain.tld" ?
Greez BeNe
RE: Fresh Install - MasterTH - 06-26-2009 06:41 AM
what happens if you do a nslookup admin.domain.tld the answer must be the ip-adress of your server