Current time: 11-06-2024, 05:09 AM Hello There, Guest! (LoginRegister)


Post Reply 
cannot enable domain
Author Message
deepjoy Offline


Posts: 2
Joined: Nov 2007
Reputation: 0
Post: #1
cannot enable domain
The domain/user status says 'Unknown error' in Domain details. Is there any way I can enable debugging or get some log messages.

My installation on Ubuntu Feisty went flawless. Enabled awstats in the setup. Logged in. Created a reseller. Created a domain/user after logging in as reseller. The domain shows in the list but with an error icon :-(

Nothing in syslog or /var/log/ispcp/*

Not sure if this is the right board for this. Pardon me if it isn't

Thanks in advance
ISP-Cp noob
11-08-2007 11:06 AM
Find all posts by this user Quote this message in a reply
joximu Offline
helper
*****
Moderators

Posts: 7,024
Joined: Jan 2007
Reputation: 92
Post: #2
RE: cannot enable domain
There is a documentation site... and
http://www.isp-control.net/ispcp/wiki/howto_debug
11-08-2007 11:13 AM
Visit this user's website Find all posts by this user Quote this message in a reply
raphael Offline
Member
***

Posts: 474
Joined: Apr 2007
Reputation: 8
Post: #3
RE: cannot enable domain
first of all check your http://admin.domain.tld/admin/ispcp_debugger.php, there you should see the error message, and then if needed say what the page joximu pointed you to says
11-10-2007 10:15 AM
Visit this user's website Find all posts by this user Quote this message in a reply
deepjoy Offline


Posts: 2
Joined: Nov 2007
Reputation: 0
Post: #4
RE: cannot enable domain
Thanks you both for your response. I should have RTFM before I asked that question. sorry.


I did what you suggested and ended up with a 'custom.conf.tpl' not found. I copied that file into the correct directory manually (it's an empty file with a few commented lines). Now I'm stuck again.
The debugger.php says
Quote:repl_tag() | ERROR: Undefined rwith!
11-13-2007 04:54 PM
Find all posts by this user Quote this message in a reply
BeNe Offline
Moderator
*****
Moderators

Posts: 5,899
Joined: Jan 2007
Reputation: 68
Post: #5
RE: cannot enable domain
Is there still the Debug modus enabled ?
Please post the complete output. And don´t forget to change the Domainstatus to "toadd".

Greez BeNe
11-13-2007 04:59 PM
Visit this user's website Find all posts by this user Quote this message in a reply
joximu Offline
helper
*****
Moderators

Posts: 7,024
Joined: Jan 2007
Reputation: 92
Post: #6
RE: cannot enable domain
The "rwith" error mostly says that you don't have all Configuration variables in your /etc/ispcp/ispcp.conf.

This happens if you upgrade from an older version.

I'd compare the ispcp.coonf with the original
http://www.isp-control.net/ispcp/browser...ispcp.conf
and see if you miss some lines (don't change the values, but you should have all variables!)
You also can go through the changes of this file and see what changed...

/J
11-13-2007 06:21 PM
Visit this user's website Find all posts by this user Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 3 Guest(s)