ispCP Daemon doesn't works / starts!

[Naradam]

so noone can help?!

[rbtux]

what does which start-stop-daemon say? is it possibly that in your installation this app is installed in another location than /sbin? I assume it is installed because it comes with dpkg...

[Naradam]

Its there....

netoriginal@netoriginal:~$ locate start-stop-daemon
/sbin/start-stop-daemon
...

[rbtux]

hmmm I can't help you then sorry :-(

[joximu]

Hi Naradam

strange problem. It's not the start-stop daemon because the ispcp_daemon itself cannot be startet by debian.
So, maybe you can do a second "make install" of ispcp (only this step) then you'll have a new binary of the daemon in /tmp/ispcp-1.0.0/var/www/ispcp/daemon and maybe this works. Have a good look on the "make" process - maybe there are compiling errors...

The daemon is compiled during make and then it should be ready to run. If your linux cannot find it then maybe you should have a deeper look into you debian... but 64Bit should be ok.

[Naradam]

Hi Joximu!

I did a new "make install" and nothing new :S The same probleme...
No errors were during the compiling...

What should I look about in my debian? It was a fresh installed etch4...

Thanks!

[joximu]

Is /var on a separate partition?
maybe mounted with "noexec"?

/J

[Naradam]

It has not been sliced, everything is on one partition (except the swap)...
How can I see if it is mounted with noexec? :$

[joximu]

"mount"

[Naradam]

khm khm :$

so:

netoriginal:~/ispcp-omega-1.0.0-rc3# mount
/dev/sda1 on / type ext3 (rw)
tmpfs on /lib/init/rw type tmpfs (rw,nosuid,mode=0755)
proc on /proc type proc (rw,noexec,nosuid,nodev)
sysfs on /sys type sysfs (rw,noexec,nosuid,nodev)
tmpfs on /dev/shm type tmpfs (rw,nosuid,nodev)
devpts on /dev/pts type devpts (rw,noexec,nosuid,gid=5,mode=620)