[Edit] What is required for ispcp on Etch

Current time: 11-26-2024, 12:17 AM Hello There, Guest! (Login — Register)

Threaded Mode \| Linear Mode [Edit] What is required for ispcp on Etch
Author	Message

rbtux

Moderator

Posts: 1,847
Joined: Feb 2007
Reputation: 33

Post: #14

RE: New at this

that depends on your setup

20,21,22,25,53,80,110,143,443,465,587,993,995 will be the most common used...

(This post was last modified: 02-21-2008 12:03 AM by rbtux.)

02-20-2008 10:57 PM

« Next Oldest | Next Newest »

Messages In This Thread

RE: New at this - joximu - 02-19-2008, 11:12 PM

RE: New at this - Krisxxx - 02-20-2008, 02:53 AM

RE: New at this - FeG - 02-20-2008, 08:39 PM

RE: New at this - Krisxxx - 02-20-2008, 08:41 PM

RE: New at this - Krisxxx - 02-20-2008, 09:09 PM

RE: New at this - psygarden - 02-20-2008, 10:04 PM

RE: New at this - Krisxxx - 02-20-2008, 10:16 PM

RE: New at this - joximu - 02-20-2008, 05:38 AM

RE: New at this - rbtux - 02-20-2008, 10:23 PM

RE: New at this - Krisxxx - 02-20-2008, 10:32 PM

RE: New at this - rbtux - 02-20-2008, 10:40 PM

RE: New at this - Krisxxx - 02-20-2008, 10:51 PM

RE: New at this - DiXeoN - 07-10-2008, 06:58 AM

RE: New at this - rbtux - 02-20-2008 10:57 PM

RE: New at this - Cube - 02-21-2008, 12:00 AM

RE: New at this - rbtux - 02-21-2008, 12:04 AM

RE: New at this - rbtux - 02-21-2008, 12:06 AM

RE: New at this - Krisxxx - 02-21-2008, 03:31 AM

RE: New at this - joximu - 02-21-2008, 05:27 AM

User(s) browsing this thread: 2 Guest(s)