Domains stuck in "Addition in progress"

[olindata]

(09-08-2009 10:49 PM)olindata Wrote:  

(09-08-2009 10:43 PM)kilburn Wrote:  

Quote:

Code:

[root@web01 ~]# telnet 127.0.0.1 9876
Trying 127.0.0.1...
telnet: connect to address 127.0.0.1: No route to host
telnet: Unable to connect to remote host: No route to host

So your server doesn't know how to route to localhost? Something is really wrong here. Do you have a "127.0.0.1 localhost" line in /etc/hosts? If not, add it....

Quote:

Code:

[root@web01 engine]# ./ispcp-rqst-mngr
[root@web01 engine]#

... and your domains got configured properly, right?

Hmm.. apparently there was something wrong with the ProFTPd config that was causing this. For some reason, there were two lines in the config file that were routing authorisation to PAM. Strange though, since I just followed the guidelines with the install and didn't use it beforehand. Anyway, once that was all good and done, the requests were processed and everything seems to be peachy.

As a general comment though, I can say that this whole thing would be much easier to setup if there was proper logging and error messages. Now, stuff is all over the place, which makes it really hard to figure out what is wrong for an ispCp n00b (not a linux n00b at all, just ispCp).

On to making my smtp work

Apparently something is still wrong here, daemon still returns 0 as its status code. Even when I stop and start the daemon, this remains the same.
I have a feeling it might have something to do with us not having installed dovecot and a bunch of other services.

The problem here is: how can I see what is going on? where does that daemon log what it is doing, and where do errors go?