Current time: 01-29-2021, 01:55 AM Hello There, Guest! (LoginRegister)


Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Virtual ethernet and ispcp_network daemon
Author Message
Nuxwin
Unregistered

 
Post: #15
RE: Virtual ethernet and ispcp_network daemon
Hello ;

I agreed with you Joxi, adding ip addresses is a job that must be done by a operating system tool.

That is already the case because the current script use ifconfig to add/remove an Ip address . Tongue

The GUI should just provide a interface between the user and operating system to manage easily the adding/change/deletion of an interface and/or an address IP. Here, the ispCP database represent the data persistence. That replaces the common flat files such as /etc/network/interfaces. The network engine script is just a layer that allows to get the data from the database and who perform the required changes on the system via the operating system tools such as ifconfig ( configure a network interface ) ip (iproute - show / manipulate routing, devices, policy routing and tunnels), brctl ( ethernet bridge administration )...

Your approach is hard to implement because the files for networking data persistence are not the same on all distributions. The configuration on the fly is easier to implement.

But I'm curious, so can you explain your solution.

Cheer ;
04-04-2010 09:37 PM
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Virtual ethernet and ispcp_network daemon - Nuxwin - 04-03-2010, 10:16 PM
RE: Virtual ethernet and ispcp_network daemon - Nuxwin - 04-03-2010, 10:55 PM
RE: Virtual ethernet and ispcp_network daemon - Nuxwin - 04-03-2010, 11:19 PM
RE: Virtual ethernet and ispcp_network daemon - Nuxwin - 04-04-2010 09:37 PM
RE: Virtual ethernet and ispcp_network daemon - Nuxwin - 04-05-2010, 02:11 AM
RE: Virtual ethernet and ispcp_network daemon - Nuxwin - 04-06-2010, 07:52 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)