ispcp no gentoo again

[joximu]

ok, this is better.

first: we don't give support for vhcs2 at least no bigger support (I don't know vhcs2 very well). There are support forums for this.
But we encourage you to use ispcp - when it's released...

on the PIII 800: the whole linux doesn't work?
how far does debian boot?

/J

[D57452]

joximu Wrote:ok, this is better.

first: we don't give support for vhcs2 at least no bigger support (I don't know vhcs2 very well). There are support forums for this.
But we encourage you to use ispcp - when it's released...

on the PIII 800: the whole linux doesn't work?
how far does debian boot?

/J

stoped after the grub had been loaded

[joximu]

Is it only one harddrive in both (P3 and P4) pcs?

There are many possibilities: where is grub installed on, how does the partitions look like, what is the size of the harddisc (older BIOS don't know the big harddiscs).

Maybe you get it to work by trying the grub commandline (afaik it's build in - see the grub website).

/J

[BeNe]

Maybe we should Stop at this point.
Look more like an Debian GRUB/Kernel Problem.
Please visit some specified sites about it.

Greez BeNe

[D57452]

joximu Wrote:Is it only one harddrive in both (P3 and P4) pcs?

There are many possibilities: where is grub installed on, how does the partitions look like, what is the size of the harddisc (older BIOS don't know the big harddiscs).

Maybe you get it to work by trying the grub commandline (afaik it's build in - see the grub website).

/J

even i install the debian etch on the PIII
it does not work either,(there is no error during the installation)

[joximu]

ok, this is moving towards pre pre installation... or system requirements...

/J

[D57452]

i am tired with that pIII, just forget about it and use p4

[joximu]

a good decision